Module Chevy

Thanks for visiting our site!
Module Chevy
Checkout Ebay Auctions For The Cheapest Prices

Check out Amazon:

Here are some more information for Module Chevy:

One of the most common problems that you will likely encounter with Chevy pickups is fuel pump malfunctions. Over time, you will begin to notice a dramatic decrease on the truck's fuel mileage and engine performance. If that is the case, replacing the fuel pump might be necessary. With a little know-how and basic knowledge on automotives, you can easily accomplish the task.

If your fuel pump is not working efficiently, then you cannot expect your vehicle to run well. Every vehicle engine operates by using a mechanical pump or a fuel-injected pump which draws gas from the fuel tank and delivers it to the carburetor or fuel injector. Most modern engines use a fuel injected pump to transfer fuel at a high pressure via an electric pump into the fuel-injection system. If your engine is quite old it may use a mechanical pump to feed gas from the fuel tank to your carburetor.

To help you fix the problem, here is a detailed guide on how to properly replace a Chevy truck's fuel pump.

Step one: Prepare the needed materials which will include the siphoning kit, transmission jack, locking pliers, new fuel pump module, needle-nose tool, gas can, screw driver, jack stands and wrench.

Step two: After gathering the materials, begin relieving the pressure on the truck's fuel system. Do this by disconnecting the fuel box relay on the fuel box. After which, you have to start the engine and allow it to run until it stalls. Then, remove the negative battery cable and use the siphon kit to get the fuel out of the tank.

Step three: Once all the fuel has been drained, pull out the fuel tank. With the help of the jack stand, raise the truck on the desired height. Then, remove the tank's shield covering as well as the EVAP canister. And make sure to disconnect all the fuel supply lines.

Step four: Next, release the ring's locking tab with the use of locking pliers. Slightly tilt the old fuel pump module and then slowly pull it out from the tank.

Step five: Clean the fuel tank's surface with a lacquer thinner or acetone before placing the new fuel pump module. Properly return all the connections that you have disconnected and then re-pressurize the fuel system, reconnect the relay battery line and then turn the engine on for two seconds and then off for five seconds. Repeat this for ten times until the engine become used to the new fuel system pump.

Read and understand this useful guideline by heart so you'll know how to appropriately replace fuel pumps on Chevy pickups.

You can learn more about common problems that you might encounter with Chevy Pickups and also great tips to make your Chevy Truck perform better and run faster at http://chevypickups.net.

Maintenance And Repairs Questions & Answers

More Maintenance and Repairs questions please visit : YesImAuto.com

1987 Chevy 4x4 305 TBI extremely poor timing?
I hve a 1987 Chevy 44 Pickup with the 305 5.0.L engine equiped with the TBI system. It sit needing repair for over a year and a few months ago I replaced the rear prime seal and the clutch. It ran near intermediate acceleration problems,...

1987 flletwood bougham cadillac how to tighten the steering helm tilt pedals?
I need any information on how to tighten the tilt rudder on my 1987 cadillac fleetwood bougham? If anyone knows any information or where on earth i can find information i would appreciate it id close to to try and find a picture on how...

1987 ford bronco 2 rope smokes?
when i start the vehicle a gray wire smokes that goes to this black circle item on the passenger side im not sure what the black thing is i think this gray cable might go to the control module does anybody no what would cause this...

1987 ford bronco 2?
my 1987 ford bronco 2 wont get fuel first would start then would run consequently when got warm would die i replaced the distribiter and control module still same exact item changed fuel presure regulater hit fuel pump reset switch same thing when we sprayed ether...

1987 Golf GL?
I have a couple question. 1. The clutch has to much of a loose impression to it, i heard it be the linkage, but where is that and where on earth can i adjust it? or do i have to buy a foreign set? ...

1987 honda crx give a hand?
I've asked this question before and i win answers that i have no idea what they connote. I know nothing about the mechanics of a coupé so please put the answer in a dumbed downed version and inform me what i can do to fix it....

1987 Honda CRX will not rust but starts fine everytime?
asked this question before and someone replied to it and said - "Mine have the same problem. I just took a couple 12 mm wrenches and in tune the throttle until the rpm was at 750 to 1000." my question is how to do that....

1987 Honda CRX will not vacant but starts fine everytime?
When I first start it it idles for about the first 3 minutes after when i make a complete stop it just cuts rotten. But then it starts perfectly fund up and keeps going until another complete stop. If i apply a little gas at an...

1987 mercury topaz diagnostic conducting tests results...?
I went and bought a diagnostic trialling device and it gave me 5 codes: 24o- Intake nouns change heat (ACT) sensor or vane air heat out of range, 13c-RPM at decline is out of range/low, 34c-Insufficient EGR flow, defective EGR pressure transducer sensor and 10- cylinder #1...

1987 Merkur problem.>won't shut past its sell-by date?
Car quit at stoplight-- wouldn't restart- towed to repair place-ran diagnostic- fire into distributor, no fire out- replaced distributor with rebuilt--car run OK but somewhat sluggish. next day-- coupé started fine-- ran melt like enthusiast might not work --no turnsignals-cannot shut offengine with key--back to repair place--...

1987 Ramcharger wont run?
the damn thing have a new hat, rotor, plugs, wires, its timed correctly, and it wont run for **** at an idle......but if you hold er ball to the walls wide unequivocal it runs good..its a 318 2brl carb stock...except the straight pipes...and suggestions??...oh yea the...

1988 190e automatic 4cycl choke and stalling while driving..?
the car starts and drive but more than a 1/2 houre the sports car started to choke and stall. while driving so it can stop anywhere anytime.. see to start the car subsidise up i have to play near the spark plugs wires then it will start...

1988 2.3 ford wont start?
have strange plugs wires cap rotor have good spark verbs plugs there showery so i think im geting gas does not give the impression of being to have drop time

1988 3.8 Bonneville engine problem.?
this car when cold runs great soon as it warm up it tries to die and sputters,jerks ect.I dont know, could it be coil pack or mass air flow? anyway to check previously replacing?thanks surrounded by advance.

1988 Bronco. Changed fuel filter, checked fuel pump and motor is pumping gas, but still dies going down road.?
Have added HEAT to see if water in gas. Any other planning. It also is sluggish going up hills which makes me believe it is a fuel problem. I will check the fuel pressure too, so need other ideas. What is this in...

1988 buick lasabre rattle nouns close at hand engine when starting and when braking?
My mom is asking this question, any lend a hand would be lovely.

1988 Buick?? cooling devotee, how is it suposed to be turned on and rotten??
been have a over heating problem when contained by traffic. I think it is not turning on properly. When I first start the engine it turns on but afterwards goes bad before any boil registers on the temp guage. its on a 2.8 V^...

1988 c2500 4bbl carb to replace 2bbl TBI injection 350cid engine?
how hard would it be to replace a 2bbl TBI beside a 4bbl carb and keep the electronic ignition from 1988, I am sick of this cr*p one time your running ok afterwards the next time its over fueling afterwards running to lean and am sick...

1988 C2500 truck 350cid 5.7l rough fester?
My truck has be running like cr*p lately runs ok but if i drive aggressive bye hitting the gas strong its starts cutting within and out why new fuel filter,cap&rotor, wires, pick-up coil,coil, control-modulator,fuel lines and have 296,500 miles on it what would cause this...

1988 Cadillac Deville?
My 1988 Cadillac Deville starts with a jump relunctacly. I did tolerate it idle running for about 30 mins. turned it rotten waited about 5-10 sec. consequently tried to start it again .nothing jumper cable were NOT on while idling Does anyone own...

1988 Chevy Cavalier defrost will not work near bake adjectives the channel up?
I can not get the defroster to blow for the drivers side with the warmness slider all the way up to hottest setting. It simply blows out the vent. If I slide it back to about partially way it will blow out but not real hot....

1988 chevy silverado gear shift wont move...why?
I have a 1988 silverado with a 5.7 liter v8 and 700r4 nouns. The Shifter lever will go down though the gears easily, but will not come final up to put the truck in Park with the knob in the "run" position. I can't...

About the Author

YesImAuto.com

what are the symptons of a faulty engine module on a v6 02 chevy malibu and how to replace one?

Symptoms are a no start condition, an intermittent no start condition, or a bad misfire as it won't fire a coil. These aren't too bad to change out as all you have to do is disconnect the electrical connections, take all the spark plug wires off, and then remove all the coil bolts and the module with coils will fall right off. Diagnose this before replacing the module as it's expensive, but a part that fails all the time. Good luck.

1992 Chevrolet Lumina APV minivan from North America - Comments
The rear door lock failed, alternator failed, heater core leaked onto passenger side floor, Distributor gasket leaked oil badly, washer fluid hose came off fitting that is under black plastic exterior grille that is very hard to remove. passenger window won't go down more than half way, headlight switch failed, passenger door lock works only sometimes, Paint peeled off front part of roof ...

Thanks for visiting!